The heat dissipation of liquid cold plate is becoming more and more common. For liquid cold plate manufacturers, it is necessary to make an objective judgment on the quality of water cooled cold plate in order to improve the quality of the equipment. Now let the liquid cold plate manufacturer introd

At present, many countries have introduced a timetable for banning fuel vehicles, which undoubtedly has great advantages for new energy vehicles, and injects strong impetus into the development of new energy vehicles. What is the future of new energy vehicles , The following cold plate manufacturer-

Many people think of the heat sinks used in computer CPUs and graphics cards. This is a radiator that only some high-end players can use, because it is more expensive. In the field of industrial electronics, water cold plate or liquid cold plate has also been widely used, but the public does not kno

The motor and inverter controller of Hongguang mini are on the rear axle. The high-voltage battery is connected to the motor inverter controller through two high-voltage DC cables. The motor inverter controller converts DC to three-phase AC to drive the permanent magnet synchronous motor.Since natur

In practical applications, the ultra-thin heat pipe in the heat pipe heat sink is usually defined as a flat heat pipe with a thickness of less than 2.0 mm. Ultra-thin heat pipes are very thin and can dissipate heat directly to the surface of electronic components, so they are widely used in mobile o

In high-power products such as large servers, liquid cooling technology is widely used. Liquid cooling technology is to use a liquid with a high specific heat capacity as a heat transfer tool to transfer the heat generated when a high-power product is running, so that the product can operate normall

Liquid cooling can significantly increase the thermal conductivity compared to gas cooling. For power electronic devices with high power density, liquid cooling is a good choice. cold plate cooling system use a circulating pump to ensure that the coolant circulates between the heat source and the co

1. The origin and development of heat pipesHeat pipe technology appeared as early as 1942, when Perkins invented and improved the thermosyphon (a simple gravity heat pipe). After 1942, Gaugler proposed the principle of modern heat pipes, but did not apply them in practice. It was not until 1963 that

The general air-cooled heat sink will choose metal as the material of the heat sink. When we choose the heat sink material, we will evaluate it based on high specific heat and high thermal conductivity. Silver and copper are the best thermal conductive materials, followed by gold and silver. . Howev