English
Pусский
Deutsch
Español
日本語
العربية
You are here: Home » News
  • The increasing need for electronic devices to operate efficiently in a higher power range has led to several technological advancements and the miniaturization of devices. In addition, power electronics are increasingly prominent in a wide range of fields such as communications, automobiles, aerospa
  • The liquid cold plate is made of copper material whether it is a CPU cold head or a graphics card cold head. As the commonly used aluminum material for heat dissipation, the thermal conductivity is also good, so why does the cold plate heat sink head not use aluminum as the cold head? As one of the
  • The most commonly used skiving heat sink is in the electronic products in our lives. Skived fin heat sinks can make the electronic products used have the effect of dissipating heat and not being burnt by the heat. With the development of technology now, the skived heat sinks produced by many skived
  • Modern electronic liquid cold plates are mainly aluminum alloys, mainly 6 series aluminum alloys. Due to the increasing electronic power density, equipment has higher requirements for reliability, life span, and failure rate during life. In this way, the flow channel structure of the water cold plat
  • As we all know, high temperature is the enemy of computers. High temperature will not only cause unstable operation of the system, shorten the service life, and may even burn out some parts. However, the reason for the high temperature of the computer does not come from outside the computer, but fro
  • The heat dissipation of liquid cold plate is becoming more and more common. For liquid cold plate manufacturers, it is necessary to make an objective judgment on the quality of water cooled cold plate in order to improve the quality of the equipment. Now let the liquid cold plate manufacturer introd
  • At present, many countries have introduced a timetable for banning fuel vehicles, which undoubtedly has great advantages for new energy vehicles, and injects strong impetus into the development of new energy vehicles. What is the future of new energy vehicles , The following cold plate manufacturer-
  • Many people think of the heat sinks used in computer CPUs and graphics cards. This is a radiator that only some high-end players can use, because it is more expensive. In the field of industrial electronics, water cold plate or liquid cold plate has also been widely used, but the public does not kno
  • The motor and inverter controller of Hongguang mini are on the rear axle. The high-voltage battery is connected to the motor inverter controller through two high-voltage DC cables. The motor inverter controller converts DC to three-phase AC to drive the permanent magnet synchronous motor.Since natur

Send a message

Copyright © 2005-2021 Guangdong Winshare Thermal Energy Technology Co., Ltd. All rights reserved