Tel: +86-13922909212   |  Email: wst01@winsharethermal.com
Large Heat Sinks
Wind power converters
Via the excitation on the rotor of the doubly-fed induction wind generators, wind power converters are capable of making the amplitude, frequency, and the phase of the stator of the doubly-fed generator the same as the electrical grid. Depending on the requirements

Wind power converters cooling solutions from Winshare Thermal

Via the excitation on the rotor of the doubly-fed induction wind generators, wind power converters are capable of making the amplitude, frequency, and the phase of the stator of the doubly-fed generator the same as the electrical grid. Depending on the requirements, it can also carry out the independent decoupling control of active or reactive power. Using converters to control the doubly-fed induction wind power generators can realize the soft cut-in control and reduce the adverse effects of the cut-in impulse current on the electric motor and electrical grid. In other words, whether a wind power converter operates stably will directly affect the stability of the electrical grid. In order to ensure the normal operation of the wind power converters, cooling is an indispensable and critical part.
Cooling solution for wind power converters (DCDC 3000W transient solution)
Schematic of the internal structure and heat-dissipating devices of Infineon: diode:34W;IGBT:91W; total 1500W;
Assuming the thermal interface material is:thermal grease 7762,thickness=0.2mm, K=4W/m*K。
Working state of the heat source:0-29s:0%;29s-30s:from 0% to 100%;30s-59s:100%; 
59s-60s:from 100% to 0%;Cycle time for one operation is 60S.

Simulation model and relevant parameters of the heat sink design:

Heat sink parameters:
 Dimensions of base plate:462*220*15mm;
 Fin thickness: 1.5mm; 
 Fin count: 92fins;
 Fin height:87mm;
 Material:AL 1060;
 Machining technique:Skived fin;
 The operation ran for 16 cycles with a total time of 960s.
Schematic of the variable of IGBT core component's bottom surface temperature vs. time: 
(Airflow:500m^3/H,IGBT node temperature = Core component's surface temperature + Core component's power*Core component Rj-c)
Simulation results of the variation of maximum temperature between the heat source bottom and the heat sink surface vs. time in cycles:
Send a message
Leave a Message
Send a message

INDUSTRY

HEATSINK

LIQUID COLD PLATE

CONTACT US

Tel: +86-13922909212 ( Mr·Li )
Email: wst01@winsharethermal.com
Add: NO.19, xingfa road, Xingfu road, Qingxi Town, Dongguan City, Guangdong Province, China.
Copyright © 2005-2021 Guangdong Winshare Thermal Energy Technology Co., Ltd. All rights reserved